中文

fep resistance high pressure jumper hose

Teflon braided hose/Teflon braided hose/high temperature

High temperature - long-term use temperature 200 ~ 260 degrees, low temperature at minus 29 degrees still soft. Corrosion resistance - resistant to acid, alkali, hydrogen sulfide, a variety of organic solution and oxidation resistance. For high corrosion solvents, petroleum, chemical, pharmaceutical, food, …

Reinforced Tubing | Nordson MEDICAL

High-Pressure Braided Tubing (HPBT) High-pressure braid-reinforced tubing is a polyurethane tubing reinforced with polymer monofilament and can be utilized for various appliions including high pressure transmission of contrast media into the vascular system. Typical working pressure of 1,200 psi is achievable, and it is EtO sterilizable.

TWO WIRE BRAID HIGH TEMP HOSE - PIRTEK AUSTRALIA

Medium to high pressure high temperature hose for hydraulic oils - both mineral and biological; Polyglycol base oils/water-oil emulsions/water and compressed air. Outer cover must be pin pricked if hose is to be used to convey air or gases above 17 bar. Features. MSHA flame resistance. High temperature resistance.

FEP Chemical Hose | Parker SW373 Series

FEP Chemical Hose - FDA, USDA, 3-A - Series SW373. Series SW373 is a premium quality high pressure, high-temperature suction and discharge hose designed to handle approximately 99.5% of commonly used acids, chemicals, and solvents, as well as food and sanitary materials. The fluorinated ethylene propylene (FEP) tube meets FDA, USDA, and 3-A

SMOOTH BORE FEP/PFA/PTFE HOSE

FEP/PFA/PTFE HOSE Rubber Fab offers a full line of flexible smooth bore FEP, PFA and PTFE lined sanitary hoses for Pharmaceutical, Food and Beverage, and Industrial appliions. NEW FROM RUBBER FAB RF-RT Smooth Bore FEP Lined EPDM Covered Hose RF-RTP Smooth Bore Heavy Wall PTFE Lined EPDM Covered Hose RF-SF SUPREME-FLEX: Smooth Bore

PTFE Hose - Yozone-Tech

3. viscous resistance is good, the inner wall of the tube is not easy to stick colloid and chemicals. 4. excellent aging resistance, can be in outdoor use for a long time. 5. excellent electrical insulation properties: PTFE as the height of the non-polar materials, has good dielectric properties, resistance, dielectric constant of 2.0 or so, Is the smallest in all electrical insulating materials.

Pharmaceutical Hoses, silicone hose, braided smooth bore

Suitable for pharmaceutical, biomedical, cosmetic and food appliions. Excellent temperature appliion range of -100°F (73.3°C) to 400°F (204.4°C). ResistoPure™ hoses are made in accordance with CFR 177.26, and meet all USP Class VI, FDA, ISO 10993, and 3A standards. Heavy duty, yet flexible.

Jumper Hose - Oilfield Mud Delivery Hose

Jumper hose with various API end fittings. High pressure and flexible jumper hose conveys high-pressure drilling liquids between mud-pump discharge outlet and the mud standpipe manifold on the drill floor. Specially compounded synthetic rubber cover has …

High Pressure Flexible Lines for Production Appliions

of a high pressure bonded hose The flexible hose lines are a bonded construction comprising steel and elastomeric materials. The principal characteristic of bonded construction is the build-up of individual layers in the flexible hose wall which are then coined into one unit through vulcanisation.

PTFE Tubing(PolyTetraFluoroEthylene) | Yozone-Tech

PTFE, FEP and PFA Tubing PTFE, FEP Heat Shrink Tubing PTFE SS Braided High Pressure Hose Medical Grades Silicone Tube • Excellent chemical resistance • Working temperature -190°C to +260°C • Greatest resistance to fatigue (Wöhler curve) • FDA approved

FRAS Suction Hose | Hoses | Pacific Hoseflex

Reinforcement: Plies of high strength synthetic cord incorperating a steel wire helix. Size Available: 25mm – 102mm Temperature:-35°C +70°C. FRAS Suction Use: Built to AS2660 Class B. This heavy-duty, fire-resistant, anti-static suction hose is ideally suited for use in high fire risk industries.

Tubing | Abbott Rubber Company

Service: A high pressure, non-marking, flexible heavy wall clear reinforced tubing for a wide variety of appliions including food, beverage, air and liquids. In compliance with FDA, NSF-51 and USDA 3A. Temperature range: 25°F to 150°F. Hose Specifiions.

PTFE flexible hoses - Unigasket

We produce hoses for the oil cooling systems installations, for the cooling oil in engines, gears of the gearbox and to for all components that have too high temperatures to be watercooled. The stainless steel braid protects the inner of PTFE tube and increases the safety and the resistance to …

PTFE Hoses and Fittings for PTFE Hoses - Tubes International

For more hoses made of PTFE and other fluoropolymers check the following groups: chemical hoses, high pressure gases, food hoses, ducting hoses, composite hoses, brake hoses. Fittings intended for PTFE hoses are specially adjusted to be asseled in PTFE hoses.

PTFE, FEP (Teflon®) Insulating hoses

Our PTFE/FEP products are produced to very high quality standards and are characterized by their extreme high-temperature resistance. GREMCO’s PTFE/FEP insulating hoses guarantee you high flexibility even with thin wall thicknesses and can also maintain very narrow tolerable wall thicknesses. Our protective hoses are very chemically resistant and have optimal sliding properties. Upon request, …

Chemical resistance FEP - Polyfluor

Chemical resistance FEP. Although FEP is similar to PTFE, there are a nuer of important differences. It has a slightly higher coefficient of friction, lower continuous working temperature and is more transparent than PTFE. FEP has a better gas and vapor permeability and outstanding UV transmission values.

TC4_PROFLEX_PFA_Hose

OVERVIEW: The TC4 ProFlex™ PFA Pureflex Hose offers very long lengths up to 1,000 feet, excellent chemical resistance, and flexibility. PFA has the same chemical and temperature resistance as PTFE and much better flex life than FEP. ProFlex industrial grade PFA was designed for customer appliions that don''t require or need pharmaceutical grade hose.

Hoses - Rubber Hoses Manufacturer from Raipur

The range of rubber hoses that we offer our clients is excellent for wielding woven textile and braided synthetic fiber. We bring forth a range that offers spectacular solutions for a wide variety of workshops, steel mills, ship building and power stations and repair yards.The variety of rubber hoses offered by us comprises seamless tube with a coination of natural and synthetic rubber.

PTFE Tubing - Working Pressure

Tubing for chromatography •PEEK •Other polymers •Stainless steel •Tubing accessories Fittings •High pressure polymeric •High pressure stainless •Nanovolume ® HPLC •Low pressure Filters and mobile phase filters •High pressure •Low pressure Safety products and mobile phase handling systems Frits •Unidense •PEEK-encased PEEK columns and guard columns Sample loops

Acetone Hose | McMaster-Carr

Static-Dissipative High-Pressure Braided Chemical Hose. Use this conductive hose in a grounded system to eliminate static buildup. The material is blended with carbon black, which conducts static charges away from the hose walls.

High Pressure Hoses | GREMCO GH

The FITCO®Hose General Purpose hoses are excellent for appliions requiring chemical resistance and can withstand high pressure up to 965 bar. In addition, the high-pressure hose for general purposes can easily be used in high operating temperature work areas.

PTFE Hose & FEP Hose from Unisource Manufacturing

Our FEP lined rubber hose incorporates textile reinforcing with a dual helical wire for vacuum rating. It is an excellent choice where appliion temperatures are higher than …

FLEXILON® Hoses - Angst+Pfister

FLEXILON ® hoses are also plastic pipes because they can often be used in pneumatics. Plastic pipes made of thermoplastic materials are calibrated on the outside and are mainly used in pneumatics and, depending on the material, to convey chemicals, oil, gas, water and much more.

Pacific Hoseflex Rubber | Pacific Hoseflex

22/3/2020· Rubber FEP Liner. Part No.: RFEP. Colour: Green / Yellow Labelling. Tube Available: FEP liner. Cover: Green EPDM rubber cover, covered and reinforced with multi-layered rubber. Reinforcement: Spiral-wound polyester cords and a double helix wire. Size Available: 1/2’’ – 6’’ ** SPECIAL ORDER ITEM ** Temperature:-40°C +177°C. Vacuum Resistance: Full Vacuum

PTFE Hose | Parker NA

FEP high pressure hose - 2380F. Parker 2380F Hoses are designed to match high demands in hydraulics or media transfer appliions. They offer reliability, versatility and a high degree of customization and are ideal for production environments. For working pressure up to 42.5 MPa. 7 Parts.

Fluoropolymer Hose, Tubing and Asselies

Chemical Resistance - Inert to practically all commer-cial chemicals, acids, alcohols, coolants, elastomers, High Pressure PTFE Hose (58 Series Hose) Pressure Fluoropolymer Hose..10 Rubber Covered FEP/PFA Hose (Jack-Chem Hose) .. 11 Convoluted Hose with Multiple Layers of PTFE

Copyright © 2020 Setone Hydraulics CO..LTD, All rights reserved.sitemap